Get the Best IPTV Service
Triax multiblock lnb holder | Page 7 | Techkings

Triax multiblock lnb holder

I can only advise what works best for me
I have completed 6 of these installations for
Family and friends. It took no time at all when
I had found the main focus l.n.b 19.2 east
This is the S.N.R AGC readings from the
Multi sat dish i posted earier .Singal finder
isn't totally accurate
 

Attachments

  • 17219096374511553050487025576136.jpg
    17219096374511553050487025576136.jpg
    1.3 MB · Views: 15
  • 17219096681922908579453992007258.jpg
    17219096681922908579453992007258.jpg
    1.7 MB · Views: 15
  • 17219098637381887797026540321089.jpg
    17219098637381887797026540321089.jpg
    1.2 MB · Views: 15
I can only advise what works best for me
I have completed 6 of these installations for
Family and friends. It took no time at all when
I had found the main focus l.n.b 19.2 east
This is the S.N.R AGC readings from the
Multi sat dish i posted earier .Singal finder
isn't totally accurate
I was going to compare, but you are using the same freq on all 3 sats, but 11068 V 23000 3/4 isn't used on 19.2 or 13
 
Yes its doable but you would get a better result with the triax dish. The triax holder as you may notice has a tilt angle built in to make tracing easier. From what I recall the sky dish was designed specifically for the sky lnb but cokeaddict has it working. The only part of a sky dish that I would use use is the wall bracket and remember bigger is better.
 
Hi guys tried a few different positions, moved the rail to below with the lnbs above but no significant difference, swapped 28.2 to bullet this lnb is back on centre as it gets a better SNR than the bullet , but I need to replace it due to the width.
1000002619.jpg
Center 19.2e
1000002682.png
So looking for a new twin for 19.2. Suggestions, another Gm202+ ?
 
Afternoon all. Is it possible to get 16e and 19.2e with multi-lnb or would I need a monoblock? Sure I’ve read in forums that they are not that good. Hoping can just use a slimline lnb. Got 1m dish pointing at 16e atm. TIA.
 
Its a struggle to get 16e and 19e as they are so close even with bullet Lnbs, but doable with decent results on 1 meter dishes.

There is a 3 degree monoblock
Search for

Inverto Black Pro 3 degree
single monoblock
 
Its a struggle to get 16e and 19e as they are so close even with bullet Lnbs, but doable with decent results on 1 meter dishes.

There is a 3 degree monoblock
Search for

Inverto Black Pro 3 degree
single monoblock
Excellent thanks. Just had a quick search. All seem to say for 80cm dish. These ok to use on 1m dishes? Do they have built in diseqc switches? TIA again.
 
Excellent thanks. Just had a quick search. All seem to say for 80cm dish. These ok to use on 1m dishes? Do they have built in diseqc switches? TIA again.
Never used one on a 1 meter dish. They do have built in diseqc switches

If this was me given your on a 1 meter id use an additional LNB on a bracket. You will get a much better adjustment and as a result better signal.
 
Never used one on a 1 meter dish. They do have built in diseqc switches

If this was me given your on a 1 meter id use an additional LNB on a bracket. You will get a much better adjustment and as a result better signal.
Yeah I think that is the route I will go down. Just been reading up on a diff forum about the effect different dish sizes have on monoblocks and it was a real struggle following it. Ha. Would you recommend 2 bullet nose lnbs or would I get away with just 1 with 1 normal lnb? I’ve just ordered a universal twin bracket for 3-9 degrees. Cheers
 
Yeah I think that is the route I will go down. Just been reading up on a diff forum about the effect different dish sizes have on monoblocks and it was a real struggle following it. Ha. Would you recommend 2 bullet nose lnbs or would I get away with just 1 with 1 normal lnb? I’ve just ordered a universal twin bracket for 3-9 degrees. Cheers
On a 1 meter dish there is more space because of the focal angle. As you would have read on this thread, bullet lnbs don't collect all the signal due to the smaller feed horn.

My opinion is youll piss 16 and 19 on a 1 meter with 2 standard LNB's, your call if you do go with a bullet. Any loss of signal using a bullet lnb is not going to be a worry on a 1 meter dish.
 
Last edited:
On a 1 meter dish there is more space because of the focal angle. As you would have read on this thread, bullet lnbs don't collect all the signal due to the smaller feed horn.

My opinion is youll piss 16 and 19 on a 1 meter with 2 standard LNB's, your call if you do go with a bullet. Any loss of signal using a bullet lnb is not going to be a worry on a 1 meter dish.
I’ve got a spare sky lnb will see how that goes to begin with. Cheers.
 
You will struggle with 1meter satellite dish
And 3° monoblock l.n.b .The focal points are designed for 80cm satellite dish
Yeah that’s the feeling I got from the threads tbh. I was tempted to see what the 4.3 one would do but I’m just going to go the multi route. Not sure you could adjust the skew either on the monoblock and it made a big difference on 16e after I adjusted it.
 
My twin bracket is due tomorrow. Is it best practice to power off all devices that will be connected to the lnb before connecting cable to them? Then again once tuned before connecting ti diseqc switch? I don’t think I done that the last time.
 
Hi all, bracket up and lnb connected to stb. Dish pointing at 16e with 19.2 offset. I am getting strength 83 quality 64 on 1m dish in NE for 19.3 Is this acceptable or need fine tuning? TIA
 
Tell me a channel on 19e and I'll check for you but are you uisng a signal meter or the receiver. Different images will give different readings and db can be a better indicator.
 
Back
Top
Flash Sale Popup