pulled the h7 apart today to get the hdd in
when i was there i thought i would look at the remote problem and the air digital logo
so to get in to the box
2 screws on the side
3 on the rear
remove hdd bay, 4 screws
remover the front bit
1 screw on left
1 screw on right
then
2 plastic tabs on top left and right
4 lower plastic tabs, spread across the base, just push up
to remove it fully, remove the two white connectors, pull out easy enough
(last bit may not need done)
to remove the front panel board
6 screws spread over it
then it just pulls out easy enough
to put back in just do in reveres
very easy done
cover up air digital logo
i folded up some black duct tape and only stuck it to the top easy, the housing pushes it in to shape
fix remote signal
i tested it out of the case and it worked really really good
so i dont know if the plastic is to dark or its something else
but what i did was bend the remote receiver bit in a wee bit
the main bit seemed to be on the side
so i bent it more to the front
not to much just a bit
closed it up and its still very good
:
