Get the Best IPTV Service
WilloBuild - WilloBuild OpenViX 6.7 Series | Page 82 | Techkings
What's new
By:

WilloBuild WilloBuild OpenViX 6.7 Series

Can you try a usb stick? Connect it with receiver in deep standby. If that works, you may have to run a disk check on your HDD. Don't forget, initialisation = format, so you will lose everything on the HDD.
 
Ok. I’m back to the original problem, I can’t get the full channel list info. I’ve got no bbc channels and quite a few other fta channels are not there. I want to do a fresh install, I thought I would just run the Willo script again but it doesn’t reflash. Also the box is now very slow booting up.
 
If the HDD was not being mounted, the restore file could not be loaded/used after reboot. As you have fixed it, please try the willowbuild install script again. That should be easiest option to sort out the EPG issue you have.

Info is EPG related.
Channel list are bouquet issue.

I presume we are dealing with EPG.
 
Last edited:
The BBC channels are not even in the list along with some others not just the info but I notice the BBC are gone as they are at the beginning. I’ve only ever gone through the Willo script through putty. I don’t know about the grog one you mentioned ?
 
Sorry, my mistake. I meant willow script.

EPG and bouquets are different things. Sort out bouquets then do EPG. Don't mix up terms. Do one thing at a time

Your bouquets are made by ABM. Post screenshots of what you have configured ABM to do.
 
I will post settings of ABM tomorrow sometimes it works and other times I get a can’t read data message. I think the box is playing up. It’s also become painfully slow to boot up
 
Abu Baniaz said:
A few people have been asking this question recently, ABM takes over a physical tuner and selects the home transponder for the provider, so it is irrelevant what channel is active before ABM activates.

LraiZers plugin uses the active tuner if it is on 28.2.
Click to expand...
So it no longer fails if the tuner was on a stream relay channel when ABM runs . Good
 
I think I’ve cooked it. The hdd had in mounted again by the time I got home so found a usb stick and mounted that and ran the willow script on slot 1 and changed over when it was doing its thing to slot one. Now it’s stuck on boot and won’t do anything.
 
I’m just about to order a new box. Is there anything I can try before I do. Is setting up a new box any different. Do I just mount the hdd out the box and run the script.
 
You must log in or register to reply here.
Back
Top
Flash Sale Popup