Get the Best IPTV Service
WilloBuild - WilloBuild OpenViX 6.7 Series | Page 86 | Techkings
What's new
By:

WilloBuild WilloBuild OpenViX 6.7 Series

Start the receiver in console mode, it should show the error. Use following commands (putty or any terminal client) one at a time, then post back result

init 4
Enigma2
(Might be lower case)
 
Armani_Vision said:
Have you ever come across the below ? I can’t seem to get it to work. Zgemma H9S
Click to expand...
I have also come across this issue on my H7, as per your pictures I got the same with the certificate thing (i presume that was the fault?) when doing an update and then it got stuck in a boot loop ending in a freeze.

The way i got round this (and shows the importance of a full backup) was to use Recovery Emmc - I used Openvix 6 6 001 Release Zgemmah7 Recovery Emmc

This worked fine and installs the basic image after, then i went into menu/setup/vix/image manager and flashed the stored full image backup and all working fine. I think as Willo said it was a glitch, but I had it too.
 
going to put this out there, i have a new ab pulse 4k box, i install willow over vix6.7 no issue, it fine until i change the skin , i have tried sky builds by kiddac, willow hd ones , Then it tries to re boot and stalls on the Willowbuild screen , you can see it try to start, but then freezes, then you can do nothing with it so i have to start again as even turning it off and rebooting wont get past the screen, and i have to reflash vix and restore willow and were working again with stock skin, done it three times now , something obvious ?i am downloading them from plugins.
 
Last edited:
The skins in my build are KiddaC's skins. I just renamed them to stop possible conflicts with the original ones because I have made modifications.
Try just installing plain ViX on another partition and then install KiddaC's skins.
 
You must log in or register to reply here.
Back
Top
Flash Sale Popup