Not booting

[bigman41]

Hi all, so I have a duo2 box and it won't boot up...it gets stuck on opening screen. I've tried to reinstall openvix via USB but box won't recognise so won't install. Any suggestions as my thoughts are it's time for a new box as processor is done

 

[pabloescaban]

Hi all, so I have a duo2 box and it won't boot up...it gets stuck on opening screen. I've tried to reinstall openvix via USB but box won't recognise so won't install. Any suggestions as my thoughts are it's time for a new box as processor is done

Try a different PSU, or, if its getting stuck at 49%, you've probably chosen an incompatible skin when trying to install your new image

 

[bigman41]

Try a different PSU, or, if its getting stuck at 49%, you've probably chosen an incompatible skin when trying to install your new image

Tried but won't read it all started when Willobuild was added to box

 

[pabloescaban]

Tried but won't read it all started when Willobuild was added to box

What image did you use before?
Can't you use that?
Have you got a different PSU to try? 99% of non booting is cured with a different power supply

 

[Ferret.]

Hi all, so I have a duo2 box and it won't boot up...it gets stuck on opening screen. I've tried to reinstall openvix via USB but box won't recognise so won't install. Any suggestions as my thoughts are it's time for a new box as processor is done

Have you different USB sticks ?

Also make sure you have no other usb device plugged into any other slots.

VU+ PSU's are very reliable to be honest seldom do they cause problem its worth a try if nothing else works, my thoughts its your USB stick they're picky with them. Try use one below 8gb and USB2 not 3 if you can.

 

[silverblack]

All these enigma 2 boxes are picky about the usb used even what machine you use to format the usb.
I used a Macbook,W11 PC and a W10 PC on an 8gb Sandisk stick and only the W10 PC worked on a Gigablue UE 4K.

 

[moshibeth]

All these enigma 2 boxes are picky about the usb used even what machine you use to format the usb.
I used a Macbook,W11 PC and a W10 PC on an 8gb Sandisk stick and only the W10 PC worked on a Gigablue UE 4K.

Low level format it with HDDGURU then fat 32 that normally fixes any issues with a sandisk flash drive

 

[bigman41]

Low level format it with HDDGURU then fat 32 that normally fixes any issues with a sandisk flash drive

I'll give it a go...Will report back

 

[Abu Baniaz]

Flashing by USB is surest method of resolving issue.

If it is starting but stalling, then it means the Linux OS is running but Enigma2 application is having issues. You should still be able to interact with it at command line and even flash it. Check on router if receiver has an IP address or use Angry IP scanner.