HELP!! Trying to flash Open Atv

[imzy]

Hey guys,

currently I'm trying to flash the box to an open atv image from open pli image.

when I insert the usb in the box, turn on box doesn't seem to flash.

Any help would be appreciated.

 

[bazcfc1]

What box do you have have tried holding power button in on front of box whilst powering on via white button at back and using rear USB port

 

[imzy]

What box do you have have tried holding power button in on front of box whilst powering on via white button at back and using rear USB port

I'm using the zgemma star h2 box, ive followed the power button step but nothing happens, it just goes through open pli start up image

 

[moshibeth]

Type ip address into the browser and open openwebif/click on terminal/type in root/enter then copy and paste command prompt line below enter

wget --no-check-certificate -O installatv.sh https://www.dropbox.com/s/nqbo698rxconave/installatv.sh?dl=1 && bash installatv.sh

 

[imzy]

Sorry I was doing it wrong, got the actual image folder 'zgemma' and put into usb and followed the power button method.
it said USB then FLSH and now it's doing it thing.
hopefully would like to put wooshbuild infinity on this.

 

[imzy]

Right guys, I'm trying to install Wooshbuild infinity. Got to the bit where I have to open terminal in openwebif but there is no Terminal option??

 

[bazcfc1]

Use putty if needed mate

 

[imzy]

I gave up, after installing open atv then wooshbuild the box became very slow and laggy.

So I just ran it back to open pli.

thank you guys.