ABM Issue

[Drox]

I am getting an error when trying to run ABM for 28.2e

As far as I know, my lnb and cabling is all fine - fta channels are working well. I have updated the ABM provider files, but still the same error.

 

[urie]

Are you on a free to air channel when trying to scan

 

[Drox]

Are you on a free to air channel when trying to scan

Yeah, I have tried bbc one and channel 4.

 

[Abu Baniaz]

You have a signal issue otherwise ABM would not fail.

Using signal finder, check that transponder using tuner A. It's vertical not horizontal. Post a screenshot of signal finder.

If you perform a single satellite scan for 28.2, how many channels do you get. This is single satellite, not just one transponder. This is not using ABM. If you don't get over 700, there is a problem.

 

[Drox]

I am getting 0% for 11778 V for both Tuners A and B.

I am using on SF8008 with a unicable lnb - so I think I cannot do a blind scan? I did a manual scan with network search on and got 712 channels.

 

[Drox]

With the parameters from KoS

 

[Abu Baniaz]

You should have used "predefined" transponder instead of "user defined". The values you are using are not correct.

The 712 channels is good sign, What has changed in your setup recently?

 

[Abu Baniaz]

Sorry, my mistake. Your last screenshot is about right. Predefined is better option. Please describe all the wiring/receivers/splitters connected to the LNB.

Can you repeat your manual scan. Do not use network search. Please ensure you use the correct tuner.

 

[Drox]

Thanks. Using the predefined tp gives me a signal on Tuner B but not on Tuner A. Nothing has changed in my setup recently, but, tuner A does use a diseqc switch. I am suspecting that the switch may have gone. (The manual scan I did before was using Tuner B).
I am suspecting the switch may have gone. I will do some more testing on it tonight,