Motor

[fozzer]

I started to loose signal on some of my satellites after the strong winds and been trying to realign it was setup with usals but can't get it working I think my motor needs resetting. Because it works with diseq after a bit of searching it finds the satellite but this is no good for usals my motor is a digipower sg-2100 when I tried resetting I hold a pin in the reset hole and blinks red then green but read it suppose to blink orange what does this mean thanks.

 

[Ferret.]

Did you install it yourself.

If so start from scratch as though you were installing it again. The winds have probably moved the whole dish motor assembly around its mounting pole.

 

[fozzer]

No my uncle installed it years ago I have moved the dish and motor and had signal on my sat meter for Thor but still had to tweak when I checked on box

 

[Ferret.]

No my uncle installed it years ago I have moved the dish and motor and had signal on my sat meter for Thor but still had to tweak when I checked on box

Its a start from scratch job then either you or your uncle .

Read this as a refresher

Motorised satellite out of alignment