FTP client wont connect to VU+ultimo

[billy bronco]

hi - cant seem to to ftp to my vu+ultimo anymore all of a sudden, ive tried different ftp clients filezilla, cuteftp, uninstalled my current Flashfxp and reinstalled...the problem is with my virgin superhub3, because yesterday i reset the superhub to factory settibgs and Flashfxp was working fine.. this morning it wont connect again..the ip address , login details are all fine..ive disabled firewall in superhub but still wont connect...any ideas.ta

 

[wullboy]

Re-boot your box, and recheck the boxes ip addy, as it may have being giving a new ip address thats not updated, and is the box running DHCP on ??

 

[billy bronco]

ive rebooted the vu+ultimo, ip address is the same 192.168.0.12...yes the box is running DHCP. still get no connection "flash fxp connection failed (connection refused)"
before i reset the superhub the ip addrress was 192.168.0.16 but it wouldnt connect then..so i reset superhub and it gave a new ip address 192.168.0.12, whic worked fine last nighht but not this morning..

 

[wullboy]

Ive used flash for about 6 years and ive always found it a good proggy, Yes ive had the odd [connection refused ] but it was usually after ive buggered about with the box and the ip has changed on me without showing it in the network set-up... I am presuming that you are using the vix image on your box, anyway.... go to network settings and do a network test, see if all come back as connected, and it just might be a router issue, i dont have the hub3, but i'm sure someone else was on here complaining about it,

 

[billy bronco]

no mate im using blackhole..trying to connect to box...how do you use telnet...i need to remove a package i installed..i fired up telnet...whats the command to connect to the vu + ultimo ?...i entered my address of ultimo but got error message..im sure theres another command prompt i enter before the ip address of the box?? see below

Welcome to Microsoft Telnet Client

Escape Character is 'CTRL+]'

Microsoft Telnet> 192.168.0.12
Invalid Command. type ?/help for help
Microsoft Telnet>

 

[wullboy]

root.. then password ???

 

[billy bronco]

no that aint it..see below...i mean after "Microsoft Telnet" you enter something like "#" or some characters to get into telnet mode...ive done it before but for the sake of me i cant remember..lol

Welcome to Microsoft Telnet Client

Escape Character is 'CTRL+]'

Microsoft Telnet> 192.168.0.12
Invalid Command. type ?/help for help
Microsoft Telnet> root
Invalid Command. type ?/help for help
Microsoft Telnet>

 

[wullboy]

Sorry but im not to glue up on telnet, although you could try putty, thats a lot simpler

 

[dsayers2014]

Download putty and use the talnet connection on that